Products / Index Cams & Internals

Index Cams & Internals

The parts no one sees and everyone depends on. Precision-molded cams, gears, and structural internals engineered to spec — tight tolerances, repeatable performance, run after run.

See the Specs↗

Why It Matters

Function over finish

Internals don't get admired — they get relied on. We engineer cams, gears, and structural parts where the spec sheet is the product: the right material, the right tolerance, and performance that holds up over the life of the appliance.

–Material matched to load, heat, and wear — not what is on hand
–Tight, repeatable tolerances validated on the first article
–Built to your drawing and inspected against it, every run

±0.02mm Typical molded tolerance

30% Glass-fill available

100% First-article inspected

0 Outside vendors to manage

Materials

Specified for the job, not the shelf

We match resin and reinforcement to the load, heat, and wear your part will see — and hold that material consistent across every production run.

Structural Glass-Reinforced Nylon PA6/66 with 30% glass fill for stiffness and dimensional stability under load.

Wear Acetal (POM) Low-friction, self-lubricating cams and gears that resist wear and fatigue.

High Heat PBT & PPS Engineering resins that hold tolerance and strength near heat sources.

Metal Stamped & Machined Steel and stainless internals where metal is the right answer.

Tolerances & Performance

Held to the number

Internals live or die on repeatability. We validate first articles, monitor process, and inspect to your drawing — so part 1 and part 100,000 measure the same.

First-Article (PPAP) SPC Monitored RoHS REACH ASTM CMM Inspected

Molded tolerance Typical, feature-dependent ±0.02 mm

Glass-fill range For stiffness & stability 10–30%

Continuous service temp Material-dependent up to 150°C

Cycle life (cams) Validated to spec 100k+ cycles

Inspection CMM + functional gauging 100% FAI

Min. wall thickness For consistent fill 0.8 mm

The Range

The parts behind the part

glass-reinforced index cam

Index Cams

Timing and detent cams molded to tight profiles.

molded gear set

Gears & Pinions

Low-noise, low-wear power transmission parts.

acetal bushing

Bushings & Bearings

Self-lubricating sleeves and thrust washers.

glass-filled bracket

Structural Frames

Glass-filled brackets and chassis components.

lever linkage part

Levers & Linkages

Actuation parts with precise pivot geometry.

snap mounting feature

Snap & Mounting Features

Integrated clips, bosses, and fastener bosses.

How It's Built

From print to validated part

DFM Review

We review your drawing for moldability, draft, and fill before tooling.

Tool & Sample

Build the tool, sample, and dimension the first articles.

Validate

First-article inspection and functional testing against spec.

Produce & Monitor

Run production with SPC and ongoing inspection.

Next Product

Decorative Hardware↗

View all products↗